Angle Struts

Albion Strut System
Side Rail Supports / Eaves Struts

Side rail supports are manufactured from pre-hot dipped galvanised mild steel and cold roll formed into an angle section 45 x 45 x 2.0mm thick.

Only side rail supports fabricated as shown will give the necessary stability under wind pressure or suction loads.

Standard Gauge Line Detail

Section Ref	Standard Gauge Line Centres mm	Dim F mm
125	60	110
146	65	115
175	95	145
207	115	165
227	115
247	150	200
265	165	215
307	200	250
341	245	295
401	300	350

Note: When side rail supports are used in conjunction with diagonal tie wires at a mid point location (see page 22 of online brochure) the actual overall length will be rail centres less 7mm. For side rail supports used at intermediate and third point location (see page 23 of online brochure) the actual overall length will be rail centres less thickness of rail.

End Cleat Types

End Cleat turned through 90. Generally used when fixing Side Rails and Eaves Beam. Top Cleat is fixed at 90 to the bottom cleat

Note: All holes in the side rail support strut are 14mm diameter except when the strut is attaching to a C section via a countersunk bolt (see page 26 of online brochure). At this position only the hole should be 18mm diameter to suit the 16mm diameter countersunk bolt.